|
Detailed Instructional DVD
for 5 Projects
|
36 minute DVD includes a
brief introduction by Jeff Snell about the AngleMag and how easy it is
to use, followed by a very through and visual lesson on
(1) How to cut a through dovetail without even marking, measuring or
laying out using the auxiliary AngleMag jig.
(2) Cutting a dovetail tenon.
(3) Cutting picture frame moldings to precise lengths.
(4) Cutting a straight tenon and
(5) Cutting a table coaster
NOTE: The AngleMag comes with a 43
Page Instruction Manual. Also included is a brief 4 minute VCD that
only explains the “AngleMag Concept’ and is not intended as an
Instruction Manual. The 36-minute DVD on the other hand gives you clear
and concise instructions that are easy to follow. This DVD will speed
up your learning and bring success quickly. Made personally by Jeff and
very highly recommended.
|
